How to use?
Step 1: Open your pores To increase the efficacy of your mask, open up your facial pores by:
o Steaming your face.o Take a hot shower, or rinse your face with lukewarm water again then pat dry with a towel.
Note: After 5 minutes the pores should have opened and the cream can be applied.
Step 2: Apply the mask
Apply in circular motion for guaranteed penetration into pores.o The
activated carbon mask is sticky and difficult to apply, but you want to
ensure that you get the perfect layer on your skin: Thin enough so that
it can adequately dry, but thick enough that it actually picks up
whatever is lurking in your pores.o If possible, avoid areas where you
have a lot of fine hair because it WILL hurt when you peel it off.o You
might need to give it a few tries before you find your optimal
Step 3: Wait
o Ideally, the mask should dry in about 15
minutes. But this often varies depending on how thick your layer is.o
Don’t rush it - be patient enough to just wait the extra couple of
moments for it to dry all the way. It might take up to 40 minutes.
4: Remove the Masko Basically you can feel when the mask is dried.o
It's crucial that you peel the mask upwards because that helps it pick
up the most pore-debris.Note: hurts a little on removal.
your Skin It’s recommended that you moisturize your skin after removing
the mask, especially if you have mixed or dry skin.